WARNING: Apparently this doesn't fit the newest version of the M18 Blower as they have reduced the size of the factory nozzle. A proper fit could be achieved by scaling the STL.
This is a little focusing nozzle I made for my M18 Fuel Leaf Blower.
I can't say it dramatically increases the air speed, but I figured I'd post my attempt anyway. I think it probably doesn't work the way I thought because the M18 Fuel Blower uses a standard fan to force air. Where some other blowers use a centrifugal impeller.
The fan produces a high velocity, low pressure stream (fine for this application). Where a centrifugal impeller would produce a higher pressure stream, allowing for a nozzle to accelerate the air.
Printer Brand:
Prusa
Printer:
Prusa Mk2
Rafts:
Doesn't Matter
Supports:
No
Resolution:
350 micrometer
Category: ToolsThe author marked this model as their own original creation. Imported from Thingiverse.