Dewalt XR Battery container

A container made to look like a dewalt XR battery (http://www.screwfix.com/p/dewalt-dcb182-xj-18v-4-0ah-li-ion-xr-battery/61372 this one) and to fit in a slot for one in a toolbox. The slide in tolerances are about 0.4mm so depending on your printer it might be too tight.

The three base STLs are one with two meshes my slicer couldn't deal with so I separated them, couldn't figure out how to combine them, if you figure it out hit me up.

Note: the model is slightly too large for now scaling it down horizontally by 4% should make it a perfect fit, I'm yet to correct the STLs

Category: Organization