Towel rack

This is a towel holder. Good to get the towel to dry.

The holes are maent for 8mm pipe.

The pipe I used was something I happened to have lying around.

The pieces are adhered to the door with 25mm x 25mm (or 0.5 above it) 2 sided "mirror attachement stickers". There is a small counter sink so the printed part is flush with the door. It also has a bit of "nobs" in it for better sticker adhesion.

The bar where the towell will hang is 3 cm from the door so you can put a bit ticker towel there too.

The slope is 40.7 degress in case you want to print with the slope face the print plate.