I love this print. Do you mind putting the filament insert lengths that are needed for this print
Self-Orienting Ratchet Socket Wrench
This socket wrench chooses the correct ratcheting direction on its own when you start using it! All you need to do is…
37
108
0
968
updated April 3, 2022
Makes
Comments
@imurfathersimba Hey there! Filament pin lengths needed are 1" for the Anvil pin, 3/8" for the Switch pin, and 1/2", 5/8", and 13/16" for the handle pins approximately. I recommend you cut a decent length of filament and simply snip them flush after inserting for the best fit though. For the Anvil pin, however, exactly 1" should be used to prevent it from touching the pawls.