Extension for Worx WG509 Leaf Blower/mulcher

I stand 2m tall, and the way I hold this Leaf vacuum causes the bag to drag on the ground (the zipper has suffered the most). So I mad this extension so I can hold it properly, higher up and closer to my body. Could be useful too if you just want more reach. The extension is 20cm long, and therefore adds 15cm to the full length + connection.

This is a prototype unit, but I only need one. I've made a few modifications from the unit I printed to make better connections and require less post processing, but it may still need some more work. Worst case it will press fit.

It might also be too long, so I've included a short 15cm extension (10cm length extension) version.

Print Settings

Printer Brand:

Creality

Printer:

CR-10S

Rafts:

No

Supports:

No

Resolution:

0.28

Infill:

20%

Filament: 3D Printing Canada PLA Orange

Notes:

With Bridge settings enabled, no supports were needed. Some of the overhangs didn't quite print perfectly, but they don't need to be.