Dungeons and Dragons / D&D Dungeon Master Screen Hooks

As a D&D dungeon master, one of my frustrations with the available dungeon master screens is that I think they're a bit too low at just under 9 inches. Using two screens and these hooks, I extended to a comfortable height of about 14 inches. Print 4 of them to support all 4 of the sides. I left enough clearance on the hooks to hang index cards as well (that's how I keep notes at a glance during play).

This is based on the official Dungeons and Dragons screens available everywhere.

https://www.amazon.com/Dungeons-Dragons-5th-RPG-Reincarnated/dp/B075G15PMP/ref=sr\_1\_2?ie=UTF8&qid=1518570395&sr=8-2&keywords=dungeons+and+dragons+screen

Print instructions

Category: Toy & Game Accessories Print Settings

Printer: Reprapguru i3 V2

Rafts: No

Supports: No

Resolution: 0.2 mm

Infill: 10%

Notes:

The print has a small inside diameter on the hooks, so a brim is not recommended for a clean print.