Script Letters - Attached - Full Alphabet Upper Case

Added Three Layer STL's of each letter which can be joined in slicer or Tinkercad - the UPPER CASE letters are in a separate post

There are two(2) postings of this font face:

1. Lower Case - Letters that can be attached

    2. Cap Letters to be used with the Lower Case to form Names or sayings 

To set up a word or name using attached letters just follow these steps - it's all done on your slicer

1. Load all the letters you need for the word or name into your slicer (Suggest one letter at a time all three layers at the same time, then move the full set to the side.

2. Set up the word or name using only the top layer #3 for each letter. When you are happy with it MERGE the letters together.

3. Leave the word or name on the slicer - now bring the middle layers #2 to the word and line them up under the top layer when finished move the merged top layer off the middle layer and merge the middle layer - repeat for the bottom layer #3

4. You should now have 3 separate layers that can be printed separately or place them one on top of the other and print as a single unit

Note: If you choose to print them as separate layers or if you have scaled the letters adjust the Z height 

Any questions just message me I'll try to assist any way I can.

This font is called Liar Script and was designed by Mistifonts.com It is a free download for personal use only