Test lead holder

This was designed to hold the test leads for my bench Multimeters and Oscilloscope leads. It could be used for any kind of cables. It slides onto Ikea type shelving. I have included one for a round shelf nosing and will add one for the square shelf as well. If there is interest I will add other adapters and parts.

A360 viewer and downloadable files:
https://a360.co/2Qmv8Nh

Print instructions

Category: Electronics Print Settings

Printer Brand: Prusa

Printer: Prusa Mk2

Rafts: No

Supports: Doesn't Matter

Resolution: 0.2

Infill: 20%

Filament: any PLA
Notes:

I designed it to not need support but the probe basket will need support. If there is interest I will design a basket that doesn't need support. You will need to flip the front part over when slicing and the shelf tab on their sides.

Post-Printing

Assembly

It screws together using M4x0.7 cap screws, the length isn't critical. You could also glue it together but then it won't be adjustable or adaptable. There are several holes to allow it to be installed at different heights on the shelf. There is a basket to hold the leads but you don't
need to use it.