Anet A8 Small Front Brace

There are many front frame braces over thingiverse, but all of them are attached to the laterar thread rods. I have my Anet anchored to a base, so I didn't need a large front frame because I could anchor the frame to the base too whit a couple of screws, so I design this model.

The screw holes are made for 3mm wide screws. The length of them depend of the thickness of your base.

Print Settings

Printer:

Anet A8

Rafts:

No

Supports:

No

Resolution:

0.2mm

Infill:

25%

Notes:

I printed mine at 0.15mm layer height, but at 0.2mm will be just OK as well.