A simple dust catcher for drilling. Includes a small knob/handle for controlling/holding the catcher without getting your fingers near the drill tip.
The bottom container's outer wall is angled at 45° so there are no supports required for this print! Just print it on its back / facing up.
Designed in Tinkercad.
Whatever material and layer height you want to use!
Recommended: 0.2-0.3mm Layer Height, PETG (better strength) or PLA+/PLA.
Supports: No
Rafts/Brims: No
Max Unsupported Overhang Angle: 45°
The author marked this model as their own original creation.