This was designed to replace anchors that had been holding up the cable tray under my IKEA desk (Signum Cable Tray and Vika tabletop which has now been superceded by Linnmon).
This isn't a replica of the original anchors, but has been working well so far. I previously replaced them a few times with drywall anchors that kept pulling out. I ended up settling on the 4mm full-slit design, but the others are included in case they're useful for your application.
Printer Brand:
RepRap
Printer:
Prusa i3
Rafts:
No
Supports:
No
Resolution:
0.4mm
Infill:
100%
Notes:
Small enough that supports were unnecessary for the overhangs. May need supports if you scale it up.
Category: PartsThe author marked this model as their own original creation. Imported from Thingiverse.