SNES Controller Plug Opener

It's hard to hold the four tabs on both sides of the SNES controller plug when trying to open it. Using metal tools also damages the tabs a lot. Hence this tool.

Try to put all 4 nipples into the holes, squeeze the tool inwards while trying to pull the innards outwards through the holes on the sides of the plug with a dental pick. It's brutal but I can't image it being any easier without a good tool.

Note the tabs on the stubborn side will still be slightly damaged if you look very closely. But like I said, it should be much better than metal tools.

Print Settings

Printer Brand:

Creality

Printer:

Ender 3

Rafts:

No

Supports:

No

Resolution:

0.2mm

Infill:

5

Filament: Any PLA Any