E3D V6 mount for an Up Plus 2
Print settings I used:
-0,1 mm layerheight (I think slightly higher won't be a problem)
-60% infill
-Printed in PETG but ABS, ASA or another material that is ok with high temps should be fine.
Parts needed:
-E3D V6
-30 x 30 fan
-40 x 40 radial fan
-M4 nut (mount to Up Carriage)
-2 x M3 nut (V6 clamp)
-4 x M2 x 5 bolt (40 x 40 fan)
-4 x M3 x 12 - 15mm (30 x 30 fan)
-4 x M3 x 8 (closing plate)
-Bowden extruder
-Bowden tube
Coming update:
Strain relief for the power cables and bowden tube, it is already prepared for this with holes so it shouldn't need reprinting when I add this.
I'm running this on a completely modified up plus 2 with a SKR board with marlin, I don't think it's possible to get running good with the original board + firmware. If people are interested I can write a short manual on how I did this conversion with the included firmware. Also designed and lasercut an enclosure that I can share but it will take a bit of work and I feel like I'm the only person left that still uses an Up Plus so I don't want to waste my time on that.
21-10-2020: Added extruder mount
Category: 3D Printer PartsThe author marked this model as their own original creation. Imported from Thingiverse.