Nice little print, fits together well. Just have to source some threaded inserts before I finish it.
Printed using ESUN PLA+ with 0.20mm layers.
Arduino Uno case
Simple case for Arduino UNO
175
1201
17
6659
updated December 16, 2022
Makes
Comments
Perhaps the most useful print I've made to date!! I love using it. However, I lack the hardware so after using a twist-tie for months I came back to remix it. I'll post it shortly
Nice case. I used the shaft off a pop rivet for the hinge
@BrettManners_1846401 These are my first choice for all hinge/pin applications. I bought a pack of 250 a couple of years ago and still have a box full left
Great Arduino Uno case. It was easy to print and the arduino fit it perfect. (edited)
Great model, very accurate, fast printing. I just forgot some support for the top part but it will do the job. Still miss the insert. By the way, why 2 inserts in the material list ? i just see one place for an insert. Anyway, thanks again for sharing
@AlanM_429175 It's for screwing down the board just in case it rattles around due to any inaccuracy
Thx a lot for this stl, printing was easy and the result is realy clean. The only issue that i have was that the hinge was a little to thin to put the filament of 1.75 mm inside but with a lot of strange and pain it works
@WyNoPrint_1632606 are you sure you printed the correct one there are 2 options and I would prefer v1 with a paper clip
@JIMIT5_205906 idk, i print the v2
would an arduino uno r4 fit in this?
@ApeleMowingY_1372612 As per the dimensions online seems like it should fit I haven't tested it myself
