RepRapPro Mendel Mono - Inductive Proximity Sensor Probe Mount for Homing and Bed Leveling

Use 8mm 5v rated Proximity Sensor (glass on aluminium bed might not work, recommend adding stainless steel sheet in between or use spring steel flex bed instead of glass as I do)

Print the part

Run through the M8x1 tap

(it has thread designed in but due to the size cleanup thread run is highly recommended)

Screw in the probe and secure it with one of the probe nuts

Amend the firmware to include z probe or just use it as more reliable z endstop as is.

(check my other listings if you're after Marlin 2 firmware for Mendel Mono with Melzi board)

Probe offset is X42 Y-10

Sensor mount nicely curves around the shroud (I use original Ormerod part cooling shroud which I highly recommend, simply requires 2x longer M3 screws)