LM2596S Buck Converter Housing

9 Apr 24 - Added improved housing that features additional vent holes on the side, as well as minor improvements such as small chamfers on all edges for a more refined model.

Just needed a simple housing for a buck converter. Text on side reads “Ya ikou!” or “Hey let's go!” → My business (www.yaikou.com)

Buck Converter(s) Used: https://www.amazon.com/gp/product/B07QKHR6PY

Assembly:

• Solder wires to the top of the pads before placing in the housing
• PCBA should just 'clip' in at the bottom
• Lid clips in. You can adjust the voltage through the vent in the lid
• Two 3mm holes in bottom to mount the housing

Before energizing the module, make sure the screws will not interface the bottom of the PCB. I left 4mm between the perimeter "standoff" and the bottom of the PCB, but check for any through-hole components that may interfere.

Print Settings

Rafts:

No

Supports: 

No

Filament: Any ABS, ASA, PETG, PLA Any

Category: Electronics