Fanatec CSL Elite P1/WRC/BMW Wheel 12mm Button

I wanted bigger buttons for my CSL elite P1 wheel like those on my Clubsport F1 when the caps are on so I designed and made new ones.  These should also fit the WRC and BMW wheel which replaced the P1 in 2021

These replace the stock buttons on the wheel and fit perfectly, they are also keyed so they don't twist in the slot so you can line decals up properly.

They fit a nice 10mm circle decal that are found on eBay or if you want to fork over the cash for the official Fanatec ones you can. Maybe you have a set but they obviously don't fit on the stock P1 rim buttons, well these will adapt the P1 wheel so they will :)

They come out relatively easily if you pop a spudger or something under them to pry the out if you want to go back to the original ones.

I made mine from PLA and didn't have any issues but ABS might be better as it flexes better without breaking for getting them in and out. I broke quite a few in PLA and refined the design to allow for more strength as I know most folk probably print in PLA (I Must have printed about 10 variations to get it right ha!)

I just printed with a skirt, 100% infill and set wall count to 2 to allow for stronger infill pattern mostly for the pegs

This is my first full design and make from scratch so any comments are welcome. you need to print 11 for a full set. It was made in TinkerCAD

Note this does not fit the big centre button if there is interest I might make a version that fits this button. Also try printing one first and check tolerances you can shift the scale up or down a percent if needed

Check out my other designs for more Sim Racing and Fanatec bits

Print Settings

Printer Brand:

Creality

Printer: 

Ender 3 Pro

Rafts:

No

Supports: 

No

Resolution:

2.0 or 1.2

Infill: 

100%

Filament: Amazon PLA or ABS Black

Notes:

Set wall count to 2 as this allows for stronger infill pattern on pegs

I also like to have bottom bed layer as Concentric as gives a nice pattern but this is just cosmetic