5/8" J Channel Jig for 12mm Pixels

This is for the 5/8th J channel that I got from Lowes. This is for the 12mm RGB Pixels.

https://www.lowes.com/pd/Georgia-Pacific-J-channel-White-0-625-in-x-150-in-Vinyl-Siding-Trim/3037104

• Currently, 2" center spacing
• Depending on which hole that you use for the pin, the original version will create options for 2", 4" or 6" spacing.
• The "short" jig saves plastic and printing time but will only do 2" and 4" spacing.

You can use the outer cut to align with your drill bit.

Print vertical, no supports needed. Print at least one pin for alignment. I do check detect bridging parameters in Prusa Slicer.