RV Camper Drawer Latch

I purchased a 2005 motor home and have been slowly fixing some of it's many problems. One was several drawer latches were broken and the latches I could get were not the same size and would require new holes. Since I did not want extra holes I made 3D models that were the same size as my originals.  On one model I added a screw hole to the center for extra strength when opening the drawer.  I have not used the extra hole version as the original design has so far worked quite well.  I designed this using DesignSpark and have included the rsdoc so it can be modified and adjusted if needed.   
I used PLA
100% infill