Clock Winder for 3D Printed Clock

This is a clock winder I made for "Clock 45" from Brian Law's Wooden Clocks.
1h 16m
3× print file
0.20 mm
0.40 mm
7.00 g
3
32
0
378
updated July 18, 2024

Description

PDF

This was created to add to my Clock 45 from Brian Law's Wooden Clocks. It needed a winder so here you go.  The square key hole on the winder is 4.6mm wide and 11.75mm deep.

 

Total print time is about 2:30 

Filament: PLA

A raft is recommended as these are pretty small.

Supports:

You should not need supports for the Barrel and Knob if printed vertically and you use a raft, but the Arm will need supports if you do not print it on it's side.

Hardware:

2x - M3x10 Screws

When fitting the knob to the arm, leave it a bit loose so the knob will spin.

 

This model is open and available to the public on TinkerCad here: https://www.tinkercad.com/things/9CYt2KKoTQs-clock-winder-v1-0

 

Happy Printing!

You can help
To help cover the expenses of printing prototypes for the models I share, please consider a donation by purchasing an item from my Amazon wishlist here

Please leave a comment and let me know how you like this model. 

Also, if you like this model, check out my other models over here:

https://www.printables.com/social/130916-hendersons-handcrafts/models

                                                       

Below are just few of my other models

Tags



Model origin

The author marked this model as their own original creation.

License