A simple hanger designed to store flex plates on the side of the printer when not in use.
There are two variants: one with through holes sized for the 5.3x51.mm BOM heated inserts and another for McMaster P/N: 94459A130 4.7x4.3mm inserts.
There is additionally a small drilling guide included. The same guide is used for both variants.
The current design has three plate slots, but could easily be modified/remixed for more if needed.
Fusion 360 project file available here.
Printer:
Railcore II 300ZL
Rafts:
No
Supports:
No
Resolution:
0.2mm
Infill:
40
Filament:
Any PETGAny
Notes:
The bracket includes a 0.5 degree angle on the face bolted to the printer. This is to make the plates to lean slightly toward the printer when stored.
Category: 3D Printer AccessoriesThe author marked this model as their own original creation. Imported from Thingiverse.