10'' rack mini itx pc case

Thanks for this! Added 2 80mm fans on the back for more cooling. Should of added a picture of the fans before I put it together. (edited)

For anyone wondering the screws / BOM, here's what I used (I'd recommend socket head screws aka SHCS, not button head screws):
- 4x of m3x8 (top, for side panel sandwich)
- 4x of m3x16 (bottom, for side panel sandwich)
- 2x of M3x16 (top front corners)
- 2x of M3x20 (bottom rear corners)
- 2x of M3x25 (bottom front corners)
- 14x of M3 hex nut

Printed in ASA. No supports. 2 walls, 15% infill (I may need to bump up to 3-4 walls, but tbd).
Polylite ASA Black & Yellow, Flashforge ASA Burnt Titanium. (edited)

Hi, would it be possible to get the CAD project files? I would like to remix to fit small fans if possible. Thanks a lot!

Nice case for my 10 inch rack. However I'll need to add some spacers as it is just a tad to short to fit the with of my other components. I'll duplicate the ear pieces without the ears as spacers

front panel with extra USBs and audio