This is a remix of https://www.thingiverse.com/thing:1902739 with some added features. My vise has the Hardened Steel Jaws inset into the cast frame so I needed the ability to add a notch in the bottom lip. I also added an optional cross-hatch pattern on the face to help grip.
IMPORTANT NOTE:
When slicing the model, make sure the settings are adjusted to avoid bridging just in between the spaces of the cross-hatching. I set a 0.8mm deep lattice, then set 5 bottom layers at 0.2mm per layer so the 5th layer was a full layer fill.
Printer Brand:
Creality
Printer:
Ender 3
Rafts:
No
Supports:
No
Resolution:
200
Infill:
20
Filament:
Any TPU
Notes:
Any filament can be used
Category: PartsThe author marked this model as their own original creation. Imported from Thingiverse.