I have a few pin badges, that would otherwise just sit in a box.
I couldn't find anything I liked that was suitable or simple enough to display them, so I drew up these three versions.
These were designed to fit Dia 26 o/d pins.
For my print I also added holes for the pin location, but have removed these as I found that not all the pins were in the same place.
I would suggest making a paper template of your badges pin position and then transfer it to the recess. Then drill out a hole suitable size. I also had to use a thin piece of rubber sheet, as one of my clasps wouldn't clamp the pin enough to be a tight fit.
Printer Brand:
TEVO
Printer:
Tarantula
Rafts:
No
Supports:
Doesn't Matter
Resolution:
0.1
Infill:
20% to 100%
Filament: filament PLA any
Category: Coins & BadgesThe author marked this model as their own original creation. Imported from Thingiverse.