Swarming in with overwhelming numbers, the small but extremely deadly Tri-Fighters close in on the Galactic Republic starfighters. Equipped with Buzz-Droid missiles, photon torpedoes and 4 laser cannons, little can be done once a few of these are hard on your tail!
Just a wee kit, a little larger than true scale to my starfighter kits.
My other Star Wars kits: X-Wing Y-Wing B-Wing TIE Advanced
Also be sure to check out Fixumdude and Fine_Engineer!
Included is the full kit card, a loop-less variant along, with the individual parts files and a frameless version for those uninterested in the format.
If it's still a little wobbly, try increasing the Z axis (uppy-downy) by 10-20%! Bribes accepted for any edits/tweaks... ;)
Always love seeing your makes! Thank you :)
Interested in selling? All files are marked as non-commercial along with any remixes created from them.
If youare interested in selling physical prints of my models anywhere, be it online or offline, you can obtain asales license when subscribed to Tier 4 of myKo-Fi memberships!
Printer Brand:
Creality
Printer:
Ender 3 Pro
Rafts:
No
Supports:
No
Resolution:
0.2
Infill:
100%
Filament: Geeetech PLA White
Notes:
It's a nice snap fit for me and my printer, results may vary! To tweak the tightness, simply increase or decrease the Z height in your slicer, otherwise a little glue can go a long way!
No tools required, however I would recommend some wire snippers and a small blade for clean-up :)Sliced in Cura! Results may vary using other slicers.
Category: ModelsThe author marked this model as their own original creation. Imported from Thingiverse.