50A Anderson PowerPole Protective Cap

Took measurements of a 50A connector and basically remade it with divets instead of pins and a small ramp on the…
14
103
2
425
updated February 28, 2023

Description

PDF

Took measurements of a 50A connector and basically remade it with divets instead of pins and a small ramp on the inside to make disconnection a bit easier on the plastic. It fits quite tight in there, about as tight as another connector would.

Bear in mind these probably wont last too terribly long in terms of plug-unplug cycles (at least in PLA. Haven't tested other materials.)

The supports can be a bit hard to remove but flush cutters/pliers and a craft knife will do the job.

Print Settings

Printer Brand:

Creality

Printer:

Ender 3

Rafts:

No

Supports:

Yes

Resolution:

0.2 mm

Infill:

80

Filament: Hatchbox PLA Black


Notes:

Sliced in Prusaslicer with "Don't support bridges" turned off because my printer cant bridge well (thats my fault).

Hotend 200C

Bed 60C

on Ender 3 v2

Category: DIY

Tags



Model origin

The author marked this model as their own original creation. Imported from Thingiverse.

License