Passive speaker - folded horn - Phone / Iphone5

Passive speaker - folded horn - for Iphone5/6
i made this to fit my Iphone5s with cover.

Inspired by Fab_ster, design in Dec 11, 2015: https://www.thingiverse.com/thing:1191352
Opened he's design in Cura for printing, the printing time was 18 hours..

So i decided to make this thing faster to print for every man...

Build from the ground up in Fusion360
Learning Fusion360, I took up this project to see how far it could take me..

V2 Bottom, is made for an Iphone5s with cover, but will fit any in that size range..
V4 Top, is a more durable with "outside" fit in bottom triangle.
V2 To fit Iphone6, make bottom 5mm higher before you print. or just open the top a little..

V1 is to be scaled down to 10%..!! (messed up the sketch from the start)
V1 will fit a little larger phones.. since there is no wall to hold the side of the phone in place.

it could be a prettier end finish, butt i have plans on future design. to let the sound travel better..

See the iPhone cover: https://www.thingiverse.com/thing:2655084

please press Like, before you print this.. and send me some money, if you have plenty :-)
paypal.me/lammesky

happy printing and good luck..!

Print instructions

Category: Mobile Phone Print Settings

Printer Brand: Prusa

Printer: i3 MK2S

Rafts: No

Supports: Yes

Resolution: 0.3mm

Infill: 20%

Notes:

printet in 60mm/s / 45mm/s

6 hours for the Botton
2 hours for the top