TTGO T-Display case

More to be added, display clips into a holder (surround.stl) which offers some protection and insulation by itself, the slide can then slide into either the close_slide which completely encapsulates the device or one with full access to the headers and battery terminals can use the open_slide.

Both slides have easy access to the front buttons which are just proud of the front, the reset button is accessible but will need a toothpick or slide back out of the case and can be reached with a finger.

Will be adding further options for batterys, stands and various modules (18650, BME280 and data logger next)

t-display_with_headers is the rough model I created for designing around, I just uploaded it to see if the stl preview is functioning yet..

Edit: added mount slide which is a slightly more solid front panel intended to have different backs attached, first back is the ext_case_small_slot which has a 14mm wide slot to leave ribbon cable hanging out or hot melt a connector into.

The mount_slide and the backs have a 2mm hole all the way through intended to poke a bit of filament to hold them together. Just using one side makes it a hinge. 2mm holes in the sides and ends of the back are also for filament that can string through and hold a pcb in place or mount assorted addons yet to be designed.

Reset button is still a work in progress, again filament can make an adjustable length pin for the reset button, I melted the end and mushroomed it over where it hits the button.