ESP32 Camera Case

Remix of Thing 3541406

I added holes in the lid for a 2 pin DuPont connector which can power the camera with +5V and Ground, as well as a small mounting screw hole. I moved the SD card slot upwards from the front a little to give room for the camera module which sits in front of the SD card slot, and adjusted the flash position slightly. I also changed the print to not require any bridging while printing. The part of the case above the SD card slot is now part of the lid print. I also slightly reduced and moved the camera hole to better match the ESP32 camera pieces that I have. The overall fit is far superior now, and using a 2 pin DuPont connector for power works well for me.

Print Settings

Printer:

Self built

Rafts:

No

Supports:

No

Resolution:

0.33mm

Infill:

30%

Filament:

White