Carrera Go!!! Track Guardrails

Guardrail for the Carrera Go!!! system 90 degree turn. The 'barrier_curve-45' part attaches to the outer rim of the 90-degrees curve. Two curve parts are connected with a connector part. At the end of the turn an 'endpoint' part can be attached for a smooth ending of the guardrail.

Attention: each guardrail part is a little bit too short, there are different endpoint parts to compensate. For example, for a 180-degree turn, use 4 curve parts, 5 connectors, one 'endpoint' and one 'endpoint-180'. Flip one endpoint in your slicer, otherwise they'll all face in the same direction.

Update: I moved the location of the connector part, so it doesn't interrupt the car-facing barrier any more. A new set of parts with a 'v2' name is available, unfortunately they are not compatible with the older parts.

Also I added 'CarreraGo_TrackSupport_75mm', which I use to create a bridge in the track. It is based on the excellent looping connector at https://www.thingiverse.com/thing:487860

Print Settings

Printer Brand:

Prusa

Printer:

I3 MK3S

Rafts:

Doesn't Matter

Supports:

Yes

Resolution:

0.2

Infill:

20%

Filament: PRUSA PLA/PETG Various