Airbrush Holder - Iwata Revolution CR (and others)

This is a remixed version of an airbrush holder.

Base was shortened to allow brush to sit in holder, cup resting fully against front edge, with a rigid hose that drops off edge of table surface.

Added curved edges on main body.  Opened airbrush opening by ~2mm to ensure my Iwata had room.

Very nice addition for my airbrush.  No more spills! 

This can be printed in one piece without supports.  The print in the pic is when I was test fitting this on my workbench and sliced the body and base to print separately and then glue together.

Added 10mm recesses for use of rubber bumpers to minimize sliding ( https://www.amazon.com/gp/product/B00K6RZ9Q2/ ).  These work well in a number of 3d printing applications.

Remixed to fit my airbrush.