Used a 4-40 tap to bore the hole, went on smoothly.
table lamp knob
Small knob for my table lamp
2.6mm hole
18
176
4
434
updated February 25, 2022
Makes
Comments
Did the job. Simple, but effective. Had to drill the hole a bit for my lamp, but works like a champ.
Perfect for my lamp knob. Had to make the hole a little bigger to fit my lamp.
I heated the remainder of the snapped off knob, and after piloting out a hole, slid this print over it. Has worked for several months without failure.
fit my lamp perfectly
Worked on my pole lamp.