Here's a shell for a GQ4-3VT11T Ford key fob that had a broken key ring. If you wanna make this, you'll need to carve off they key ring as seen in one of the pictures. There's on file for one without a Mustang logo as well. Convertible not included.
Printer Brand:
Creality
Printer:
CR-10
Rafts:
No
Supports:
No
Filament:
Hatchbox PLA
Notes:
I used a Multipass Multicolor technique like Devin Montes's "Single Extruder Multicolor in Cura Tutorial // Multipass 3D Printing" Youtube video to embed the Mustang logo. From there I did two filament swaps to get the yellow band. Finally, I paused the print once the angle started to get steep and pushed key fob into the shell. I would also suggest using a "Z hop when retracted" so that it won't ram into the fob once it gets close. I would suggest viewing travels after the last pause when the fob will be inside and checking that it won't run into the embedded fob.
Category: AutomotiveThe author marked this model as their own original creation. Imported from Thingiverse.