Very Nice - Thanks for the Post
Monogram Letter C with STL File added 4/29
Letter C approx. 5"/125mm x 5"/125mm -using exposed Octagram Spiral infill.
20
145
1
416
updated February 6, 2022
Makes
Comments
If your working off the g-code file I do not believe you can do anything except slow down the print speed and switch to a smaller nozzle size - calibrate your printer - tighten all the screws to make sure there are no loose parts - check your belts - Your not giving any information so there is really no way a specific remedies can be suggested - Art G
@ArtG I’m using the STL file for both the K and C. I sliced the backing off to just leave the outline of the letter. I then resized the size about 150%. The lines look like they maybe amplified when resizing that were always there but not obvious.
When i scale this up to about 150% i get a lot of lines and artifacts around all the inside and outside edges. Anyone experience this and is there a way to clean it up?
Cathy
The STL is only about 30% of the print the most important part is the slicer settings. Look for how to expose infill in the knowledge section of the Prusa site and you'll see what I mean.
How do you want to change the print? Maybe I can help you.
Upload the STL files please.