Dewalt Guide Rail Square & 45 degree

Remix from db's excellent Dewalt Track Saw Guide. 

I made it so you can use it both at 90 and 45 degrees. 

Also I made the two retaining nuts into one. I hope this will add rigidity.

Print instructions: 

Print the track guide with 0.3mm layer height, 4 perimeters, 15% infill, and without supports

Print the long retaining nut at 0.2mm layer height, 2 perimeters, 15% infill, and without supports.

Hardware:

2x M3 nut
2x M3x12 screw