RPi Zero and Zero 2W snap-in-case and stand

The case is based on the Raspberry Pi Zero W Snap-In Case Remix of Bigjeffrey.

I modded it and designed a stand for it.

The V1 stand is friction fitted and I havent tested the V2 yet. 

If you want to use a heatsink, I would recommend installing it after the RPi is inserted into the case, otherwise you may have problems closing the case.

I have testet it with RPi Zero and Zero 2. Both fit great in the case.

If you want to use a Raspberry Pi Camera (V. 1.3, V. 2 or HQ) it should work fine. But I have tested it only with the V. 1.3.

Printed the stand with 0.3mm and the case with 0.2mm layerhight.

I edited the model in order to make the use of the ribbon cable easier. Moreover I made a stand for it and a version, where you can use a heaksink.