This is a simple axolotl model that should be very easy to 3d print, only requiring a couple of super short bridges.
Printer:
Artillery Sidewinder
Rafts:
No
Supports:Yes
Resolution:
200
Infill:30
Filament: PolyMaker PLA
Notes:
You only need a tiny bit of supports on the overhang under the eyes, other that that you should be good. I would recommend using paint on supports (like in prusaslicer) for that if you can.
Category: SculpturesThe author marked this model as their own original creation. Imported from Thingiverse.