Mason jar lid for dry ingredients

A very handy pour spout lid for jars
58m
2× print file
0.20 mm
0.40 mm
12.00 g
62
109
1
614
updated January 30, 2022

Description

PDF

A lid for a “Mason” jar that provides a pour spout as well as a opening for a measuring spoon and a leveling edge.

Print in PET-G (though I am sure PLA would work as well) at 0.2 layer height. The “base” is printed without support, but the “door” required a small amount on the build plate for the “ears” that extend behind the hinge pin.

The two parts are joined using a tool to snap the hinge pin on the door into the base.

1. put the door inside the opening in the base and open the door fully

2. using a flat tool, like a screwdriver, snap the hinge pins on either side of the door into the notches in the base. (See photo). This works best if you install the base into a jar and screw the ring on tightly first.  

DON'T try to press these into the notch with out a tool as the hinge pins will break off.

 

Tags



Model origin

The author hasn't provided the model origin yet.

License