Clamp holder for a 3018 CNC milling / engraving machine Ver.2

Clamp holder for a 3018 CNC milling / engraving machine

You need two long M5 screws or threaded rods and four M5 nuts to melt (with soldering iron) into the handwheels and holders. One M5 washer and one clamping block.

Saw off the head of the long M5 screw and glue the threaded rods with Loctite thread lock into the nuts.

With the rear screw you can adjust the height so that the holder is straight.

New, extended version 2 with 65mm length
Pressure plate to distribute the pressure on soft material.