Garden Hose Holder Using Filament Spool

This is sized to work ideally with Hatchbox spools which are ~68mm outside to outside. Will also work with many others that are close (~+/-5 mm). It is shown on a no-name brand spool that was ~64mm wide. Spools will flex a bit so it doesn't have to be perfect. I match drilled and used #6 wood screws to attach to spool.

Print instructions

Category: Outdoor & Garden Print Settings

Supports: No

Notes:

I printed mine using petg with 2 perimeters and 15% triangular infill and that seems ok. If you use pla you may want to go a bit thicker. I used 90g of filament.

Update 2/3/2024:  Added new version that prints in one piece -“Hose Holder Larger 1 Piece".  This fits on most printers but it will hold a lot of garden hose.  Has coin anchors in the model to help it stay on the bed. Just cut them off when done. I used nylon when I made mine. I included the Fusion file as well.