Klipper Pressure Advance Tower V2

A faster and easier to read, calibration tower for Pressure Advance in Klipper
79
1683
13
5785
updated January 24, 2022

Description

PDF

I prefer this model better than the original.
Lightweight, fast, & easier to read.

Print:
1 Bottom layer
0.2mm layer height
1 Perimeter
0 Top layer
0 Infill

Set all speeds to 100mm/s, except the first layer speed. Use your default value.


Important in Prusaslicer:
Under cooling: Set to 0 "Slow down if layer print time is below"
Otherwise 100mm / s cannot be achieved.
And
Turn off "Lift Z", during retraction, so as not to falsely trigger the TUNING_TOWER COMMAND .... procedure.

Continue the procedure.
https://www.klipper3d.org/Pressure_Advance.html

For Direct drive extruder, I prefer to use FACTOR = .01, instead of FACTOR = .005.
The precision is good enough anyway, and the printing time goes twice as fast until you find the sweatspot.

Tags



Model origin

The author marked this model as their own original creation.

License


Highlighted models from creator

View more