Dye LTR Paintball Loader Speedfeed

This is an alternative to other speedfeed options for the DYE LTR. It allows you to run a speedfeed and still open the loader fully for loading/unloading. Similar to how the spire/ctrl/r2 loaders function. You can use normal LTR speedfeeds. I tested with the GXG and Dye speedfeeds.

Uses magnets to hold the lid down while in use. Also, has a rain lid option held on by magnets. 

Use a high impact filament, such as Polymaker PolyMax. 100% infill and .2 layer height. Print orientation is important. Does not require supports, but cooling can be an issue on the hinge. 

I recommend using sandpaper or a file to rough up the surface where you glue the magnet holder to the loader. Use super glue to attached the magnet holder to the loader. The magnets are held in with super glue. Use the factory lid pin for the hinge. The screws are meant to go through the holes already in the speedfeed. 

5 x 8mm M3 BHSC

5 x M3 nut

6 x 6x3 mm magnet (For holding closed)

6 x 5x1 mm magnet (For rain lid)