Gridfinity MagSafe 2-in-1 Charging Stand

This is a MagSafe 2-in-1 charger designed to fit down into a 2x2 Gridfinity block and accommodates the bulkier USB-C adapters of cheap Amazon charging pads. It is designed specifically around these charging pads which cost $12.99 for a two pack. Plug it in to existing USB-C ports or grab a two-port USB-C charging block for $6.99 and you have a 2-in-1 stand for under $20. (Affiliate links)

This design prints in two pieces and slots together securely without any tools or adhesive. I was not able to upload my .gcode file but make sure to follow my support settings and print orientation below. 

The cable channel for the horizontal puck needs some revision, expect a small piece to break off. I tried a few solutions but I needed to move on from this project.