I re-created the planter from scratch, because the low-poly-version would have shown visibly in the print.
Inner measurements are the same as in the original:
Inner diameter: 62mm
Inner height: 56mm
Wall thickness: 2mm
Printer Brand:
Creality
Printer:
Ender 3 Pro
Rafts:No
Supports:
Yes
Resolution:0.2mm
Infill:
15%
Notes:
I put support blockers on the eyes and the nose.
Other than that I mostly used the settings from the original file:
Support Structure: Normal
Support Overhang Angle: 60°
Support Density: 15%
Support Z Distance: 0.1mm
Support Distance Priority: Z overrides X/Y
Support Interface Thickness: 1mm
Support Interface Density: 100%
Category: Outdoor & GardenThe author marked this model as their own original creation. Imported from Thingiverse.