P1S Corner Raspberry Pi Camera

I wanted a better frame rate camera to monitor my prints. I mounted a Raspberry Pi Zero 2 W in my P1S and mounted an Arducam for Raspberry Pi Zero Camera into this housing into the corner. You can angle the housing whichever way you like. I mounted the Pi in the printer with a command strip and ran a cable out of the bottom (where the bento box filter cables run out) to power it. 

I monitor the feed via RTSP. I used these instructions for setting up the Pi: https://james-batchelor.com/index.php/2023/11/10/install-mediamtx-on-raspbian-bookworm/

Parts Needed:

Raspberry Pi Zero 2 W: https://www.raspberrypi.com/products/raspberry-pi-zero-2-w/ 

Micro USB Pigtail 2 Wire Power Cable: https://www.amazon.com/dp/B0DG5XG7XB 

5V 3A Power Supply Adapter w/DC Terminal Connector: https://www.amazon.com/dp/B0B51R96LB 

Raspberry Pi Case: https://www.amazon.com/dp/B09XK36QNB