Autel VCMI+ EVDiag Box Handle

My main goal for a handle was that i could mount and dismount it without destroying or drilling a hole in the VCMI.  Despite that Snap-fit design it has plenty of grip on the VCMI.
To accomplish that grip i did make it pretty tight. So pleas make a test print
( around 5mm ) to check the fit and adjust the scale if necessary. 

Printing:

• Material: Pla/Pla+ is enough 
• Perimeters: at least 3 Walls
• Infill: ~25% 
• Support: classic support for the handle connection
• Orientation: the round handle should be vertical that the layerlines not splitting apart while installing.

Installation:
Place your VCMI on the side with the handle/bigger tap (see Picture), now you should be able to bend the smaller tap over your VCMI. 

Don't give up, after the first installation you should know how it works ;-)

Edit: I did add a Handle for the EV Diagnostic Box (Breakout Box for EV components). Printsettings an Installation is the same