To make my Ikea lack enclosure fit under a shelf above it, i had to lower it. I did this by cutting some length of the…
136
614
22
3461
updated January 16, 2022

Description

PDF

To make my Ikea lack enclosure fit under a shelf above it, i had to lower it. I did this by cutting some length of the lower table's legs. This revealed a hollow leg that doesn't look good and could potentially scratch the floor. To fix this issue i made these table leg feet that pressure fit on the legs.

V1: This version has holes for screws.

V2: I found that V1 pressure fit to the legs and didn't need the screws, so I removed the mount.

Installation

Step 1: push the part on the table leg on a 45° angle.

Step 2: rotate the part so that the complete leg is in it, then push down to pressure fit it over the leg

Category: 3D Printer Accessories

Tags



Model origin

The author marked this model as their own original creation. Imported from Thingiverse.

License