Gonk droid candy dispenser

This 3D-printed candy dispenser is shaped like a Gonk Droid from Star Wars and dispenses M&Ms when pressed. The original one powers machines; this one powers you—with sugar!

Assembly instructions

1. join the “door” and “connector” pieces. The connector should point away from the flat side of the “door”, like in the picture below.
   
2. insert the joined pieces into the “bottom” part with the flat side of the “door” upwards. 
   Slide the “floor” part into the “bottom” and hook the “connector” into it.
   
3. insert the springs
   
4. fasten the springs with two pieces of filament
   
5. Insert the two “padding”s into the grooves
   
6. Attach the legs to the bottom of the “floor”.
   
7. Snap the “top” part onto the “bottom”, fill the droid with candy and snap the “lid” on.