PAM (Poseable Artist's Model)

For the first paid release from Lucky 13 Toys, I have followed the will of the people and created a figure with some curves. Here's PAM, the Poseable Artist's Model.

This super-articulated figure snaps together with no glue or screws and makes the perfect desk toy or artist model. And it's compatible with Dummy 13's accessories!

Important: please allow at least one hour after purchase for the files to become available for download. After that, you can email me about it. I'm not trying to rip you off, I promise.

Printing

Parts are divided into body, joints, and hands.

The body and joint parts can be printed individually, or joined together on runners just like Dummy 13. If printing separately, check the file names to see how many are needed of each part: e.g. body_upperArm_2x gets printed twice.

The hand parts will require support, so they are kept separate. I recommend tree supports.

As with all my figure designs, you will have to print the joint parts with ABS, ASA, or PETG for best performance. Sorry, no PLA or the joints will get floppy over time.

Good bed adhesion is critical for this print. Make sure your bed is clean (with soap and water, not just IPA) and consider adding a brim, especially for the “body” parts.

I recommend getting at least one successful print of Dummy 13 under your belt before starting on this project.

Recommended settings (100%, 0.4mm nozzle)

Assembly

Follow the assembly instructions below to put everything together. Everything is snap-fit; no glue or extra hardware is needed.

Assembly may take some firm pressure but you should not end up with bloody fingers. If parts are too tight, try sanding down the mating parts slightly or applying a little heat; or reprint the joints with a small amount of XY compensation.

SAFETY TIP: Always wear a respirator when sanding plastics of any kind! Your lungs will thank you!

Compatibility

At the default scale, PAM is 1/12 of life size.

Any handheld accessories designed for Dummy 13 should also be compatible with this model. Alternate heads should work as well, just make sure to grab the head frame piece from Dummy too.

This model is compatible with the display stand 2.0 and simple display stand using the included adapter.

License

Please understand that this is a paid download for personal use only. You may not share remixes of this design. If you'd like a free figure that you can remix and share to your heart's content, check out the 13 series!

If you would like to sell prints of this model, please join my Printables Club to obtain a Seller License.

Thank you for supporting me with your purchase. Sales of this model help me towards my goal of becoming a full-time designer!