Reolink Doorbell Wedge with Guides

Reolink Doorbell Wedges

Great for mounting the doorbell to walls that are parallel to the door. This model has the same mounting dimensions as the original wedge from Reolink, both on the wall and the doorbell itself. It includes the 4 tiny guides for attaching the mounting plate at the right position, and uses the same screws as the original doorbell. Screw holes are small enough to self tap slightly, so you don't need any inserts. In short, you should be able to swap this in without any other hardware or issues.

Have tested in both PLA and ASA - the pictures showing the doorbell mounted are in ASA, the others are PLA. Both work fine, but follow the usual preparations for ASA (pre-heat the chamber, etc).

Let me know if you need a different angle, though this design probably can't go more than 45 degrees because of the mounting hole setup.

15 degrees is the same as the stock wedge that comes with the camera, but these models then add a downward tilt to a left-facing mount, useful for keeping an eye on packages at the door.

Note: The 45°-Right 10° Down version has a reduced upper mounting hole, to account for the wild curves involved. Make sure you check that this will suit your mounting arrangement.